Titanium Standard Screw Connector Abutment CH2.1

Titanium Standard Screw Connector Abutment CH2.1

Intended Use

The Titanium Standard Screw Connector Abutment CH2.1 is intended for use as a prosthetic abutment in screw-retained implant restorations on compatible CH2.1 conical connection implants. The component provides a stable connection between the implant and the prosthetic restoration, supporting long-term fixation and functional loading of implant-supported prostheses.

The abutment is designed for permanent restorations on fully osseointegrated implants and is suitable for both single-unit and multi-unit restorative procedures.

Indications

The Titanium Standard Screw Connector Abutment CH2.1 is indicated for:

- Screw-retained restorations
- Single-tooth implant restorations
- Implant-supported bridges
- Full-arch restorations
- Fixed implant prostheses
- Implant rehabilitation procedures
- Prosthetic restoration of osseointegrated implants

Clinical Procedure

Implant Evaluation

- Confirm successful osseointegration of the implant.
- Verify compatibility of the implant and prosthetic components.
- Ensure all components are clean, undamaged, and sterilized before use.

Abutment Installation

1. Expose the implant platform according to the clinical protocol.
2. Remove the healing abutment or cover screw if present.
3. Position the Titanium Standard Screw Connector Abutment CH2.1 onto the implant.
4. Engage the abutment with the internal thread of the CH2.1 implant connection.
5. Tighten the abutment using a compatible 1.25 mm hex driver according to the implant system protocol.
6. Verify complete seating and stability of the abutment.

Prosthetic Restoration

1. Fabricate or prepare the screw-retained restoration.
2. Seat the restoration onto the abutment.
3. Insert the Titanium Prosthetic Screw 1-72 UNF (701249).
4. Tighten the prosthetic screw using the appropriate driver according to the recommended prosthetic torque protocol.
5. Verify passive fit, complete seating, and restoration stability.
6. Check occlusion and adjust if necessary.

Final Restoration Verification

Before completion of treatment:

- Verify passive fit of the restoration.
- Confirm complete seating of the abutment.
- Check prosthetic stability.
- Verify proper occlusal contacts.
- Seal the screw access channel according to the restorative protocol.

Removal Procedure

1. Remove the restorative material covering the screw access channel.
2. Loosen the Titanium Prosthetic Screw 1-72 UNF (701249).
3. Remove the prosthetic restoration.
4. If required, remove the abutment using a compatible 1.25 mm hex driver.
5. Inspect all components before reuse or replacement.

Cleaning and Sterilization

- Remove contaminants and manufacturing residues before sterilization.
- Clean using approved medical device cleaning procedures.
- Rinse thoroughly with distilled or deionized water.
- Dry completely before sterilization.
- Sterilize before use in a steam autoclave: Temperature: 135°C (274°F)
- Follow validated sterilization procedures and local regulatory requirements.

Warnings and Precautions

- For professional dental use only.
- Use only with compatible CH2.1 implant systems and prosthetic components.
- Verify complete seating before final tightening.
- Follow implant system torque recommendations.
- Do not use damaged or deformed components.
- Components showing signs of wear, deformation, or damage must be replaced.
- Ensure proper prosthetic fit before final restoration delivery.

Storage

Store in a clean, dry environment protected from contamination, moisture, and mechanical damage.

CadCam